If you’re in need of a lightweight table or desk that can be assembled and disassembled with ease, we have the solution for you! With PVC pipe and just a few fittings, you can turn any piece of wood into a table or desk that fits perfectly in your home.
Here’s what you need:
1. 4 PVC table Caps (with screw tabs)
2. 4 PVC End Caps
3. PVC Pipe Cut into 4 equal Lengths
4. Screws (about 12, screw length will depend on thickness of table top)
5. Wood for Top (3/4” or 1” thick is common, 42” wide x 24” depth is a common desk size)
6. *PVC Primer and Cement (Use if you want a permanent structure)
The size of PVC pipe you’re using can vary as well, but 1” and above are common for desks and tables. Make sure that all of your pipes and fittings are the same size before getting started. We’ll use 1” for our project.
Step 1 -
Take your wood and make sure the dimensions are the right size for your desk or table. Measure the thickness of the wood to make sure your screws are not going to go through the wood entirely. Determine the top and bottom of your table then flip the wood so the bottom of the table is facing upwards.
Step 2 -
Use a tape measure near the corner of the wood and measure about 3” from the top and then 3” from the side so that your lines intersect, creating a 3” square at each corner of the wood. You’ll place your PVC Table Cap where the lines intersect.
Step 3 -
At the intersecting lines, attach each screwcap to the bottom of the wood.
Step 4 -
Determine the height of your desk or table and cut 4 equal lengths of PVC pipe to that measurement. 28” is a common length, making the bottom of your table or desk sit at about 28-1/2”.
Step 5 -
Insert one PVC pipe into one of the table cap openings. Repeat until all table caps have a pipe inserted. (Use PVC primer and cement if you want a permanent solution).
Step 6 -
Take the 4 PVC End Caps and place them on the end of each PVC pipe. (Use PVC primer and cement if you want a permanent solution).
Step 7 -
Flip the table or desk over and set it up in your desired spot. Finally, you’re all set!
Making a table or desk out of PVC pipe and fittings can be done in a few simple steps and at a fraction of the cost compared to tables and desks bought at the store. Order your supplies now and build a table that will provide you with a new space to work or play.